|
 |
The feeding part has Twin screws and the inlet is large, through which a bunch of material can be fed directly.
The screws and casing part is easily disassembled. Also, cleaning is made easy.
Because of the shape of the Twin screw, a large conveying capacity is achieved and a large quantity of material can be extruded. |
 |
HTC type Twin extruder
Reinforced kneading type
|
TEC type Twin extruder
|
STE type Twin extruder
|
Twin straight |
Twin tapered
|
The Twin tapered screws are rotated in different directions, used for forming, extrusion and granulation etc. Pressure zone is limited and heat generation is low.
Therefore, this type is also suitable for highly frictional materials, including thermosetting resin, ceramics etc. |
|
Single straight |
Single tapered
|
| The inlet and feeding part has Twin screws, and the pressure zone has Shingle screws. This type is widely used for forming, extrusion, granulation and straining. The advantages of the Twin screws, that is, large inlet, easy material supply, and secure material feeding, are combined with the advantages of the Shingle screws, that is, stabilized extrusion pressure, less residual material on the head, and easy cleaning. |
|
|
 |
*Super-forming system
SPS type Twin extruder
| The kneaded material is sheet-formed. |
| step1. |
The kneaded material is sheet-formed. |
| step2. |
Extruded by the Twin extruder. |
| step3. |
Formed as standard sheet by the primary roll. |
| step4. |
Formed as fine sheet by the secondary roll. |
| Combining machines enables various system configuration. Roll mill operation is highly rationalized, enhancing operational safety. |
|
|
|
|
